Tech-Tube High Pressure Tube plugs

Our plugs are proven with rated holding pressures up to 480 bar. When properly installed these plugs remove all the guess work of installation. No welding, no tube sheet damage, No worry.  Use our complete line of plugging equipment to properly install in either the near or far end applications. Tube Plugging has never been easier, simply use the supplied brush to clean and prepare the tube then "snap it in place". The entire procedure takes less than 1 minute per tube 

• Broad expansion range of .020” or 0,51mm per plug
• ALL tooling accessories are completely interchangeable with the current breakaway system's.
• Superior stock inventories
• Especially useful for Feedwater heater applications
• Used for any application where the Tube to Shell differential pressure is greater than 48 bar
• Savings of up to 80% over other plugging methods

Tech-Tube Medium Pressure Tube plugs

Our plugs are proven with rated holding pressures up to 48 bar. When properly installed these plugs remove all the guess work of installation. No welding, no tube sheet damage, No worry. Use our complete line of plugging equipment to properly install in either the near or far end applications. The entire procedure takes less than 1 minute per tube.

•  Industries broadest expansion range of up to 3.4mm per plug

•  ALL tooling accessories are completely interchangeable with the current breakaway system's

• Superior stock inventories

• Used to plug ALL condensers or Petrochemical Plant tubes meeting the 700 PSIG maximum differential operating pressure

• Savings of up to 80% of other plugging methods

Tube Testing Guns

Fast and easy to use system to test heat exchanger tubes with air pressure. To be used for tubes from 7 to 31mm ID. Find leaks in seconds! Can be used with regular air pressure up to 10 bar with only 1 air connection. 

BACK